Viking VCWB300RSS Guía de instalación descargar pdf (Pagina 13)

Before moving the wine cellar in place,

confirm the finished dimensions, electrical

location, minimum door and shelf clearances,

and door panel instructions. (See pages 3, 4,

5 & 6).

. Position wine cellar in front of

utout.

2. Verify operation by plugging

power cord in receptacle.

PPoowweerr

sswwiittcchh wwiillll bbee sshhiippppeedd iinn tthhee

““OONN”” ppoossiittiioonn aanndd sshhoowwrroooomm

sswwiittcchh wwiillll bbee iinn tthhee ““OOFFFF””

ppoossiittiioonn..

(If showroom switch is

switched to the “ON” position,

showroom mode is engaged and

power is shut-off to the

compressor. This mode is for

showroom display only).

Power “ON/OFF”

switch

Showroom

switch

3. Roll wine cellar into cutout to within 3” (7.6 cm) of being flush with cabinets. To avoid kitchen cabinet damage,

place cardboard between cabinets and wine cellar. Push cardboard back with wine cellar and remove cardboard

when wine cellar is in place.

4. Lift the wine cellar off the rollers, adjust to desired height and level wine cellar by using a 5/16” hex head wrench.

(Refer to Figure at the right)

a) To raise/lower right side rear, rotate the right side rear hex rod.

b) To raise/lower the left side rear, rotate the left

side rear hex rod.

c) To raise/lower the right side front, rotate the

right side front hex rod.

d) To raise/lower the left side front, rotate the left

side front hex rod.

NNOOTTEE

: DO NOT use an electric driving device.

Overtightening can cause damage.

5. Align wine cellar with sides of cabinets by adjusting

leveling legs. Rotate leveling legs until firmly in

place against floor.

6. To secure wine cellar, raise unit until compartment

cover is firmly seated under the soffit or anti-tip boards.

7. Open door. Control panel should be lit. Verify the position of the power on/off and showroom switch if there is no

power to wine cellar.

VVIIEEWW SSHHOOWWNN WWIITTHH KKIICCKKPPLLAATTEE RREEMMOOVVEEDD

SECURING THE WINE CELLAR (3 OPTIONS)

OPTION 1

If a solid soffit is 1” (2.5 cm) or less above the wine cellar, anti-tip boards are not required. To secure the wine cellar

raise unit until compartment is firmly seated under the soffit.

OPTION 2

If a solid soffit is not available or soffit is more than 1” (2.5 cm) above wine cellar, center wood boards on rear wall 1/4”

(.6 cm) maximum above wine cellar. Attach wood boards to wall studs with six of the provided wood screws, making

sure that screws are engaged in wall studs 1 1/2” (3.8 cm) minimum and that boards extend 2” (5.0 cm) minimum over

the top rear of wine cellar compressor cover. To secure the wine cellar, raise unit until compartment is firmly seated

under the anti-tip board.

OPTION 3

Position the wood block over the unit and secure it to wall studs using eight of the provided wood screws and “L”

brackets. Make sure screws extend a minimum of 1” (2.5 cm) into each of the two wall studs. The wood block must

extend a minimum of 3” (7.6 cm) over the unit. To secure the wine cellar, raise unit until compartment is firmly seated

under the anti-tip boards.

DDiissccoonnnneecctt ppoowweerr aatt bbrreeaakkeerr oorr ttuurrnn ppoowweerr ddiissccoonnnneecctt sswwiittcchh

ttoo OOFFFF ppoossiittiioonn bbeeffoorree ppeerrffoorrmmiinngg aannyy iinnssttaallllaattiioonn

pprroocceedduurree.. FFaaiilluurree ttoo ddoo ssoo ccaann rreessuulltt iinn ddeeaatthh oorr eelleeccttrriiccaall

sshhoocckk..

Solid Soffit

1”

(2.5 cm)

or less

1/4” (.6 cm)

maximum

Rear

wall

2” (5.0 cm)

minimum

OPTION 1

OPTION 2

OPTION 3

Two 2X4

boards

attached to

wall with six

wood screws

(minimum)

1/4” (.6 cm)

maximum

3” (7.6 cm)

minimum

“L” bracket

with (4) screws

on each end.

(1) 2X4

attached to

both “L”

brackets -

minimum of

1” (2.5 cm)

screws

Screws extend

minimum of

1” (2.5 cm)

into each wall

stud.

WARNING

1 2 ... 8 9 10 11 12 13 14

Comentarios a estos manuales

Sin comentarios

Viking VCWB300RSS Guía de instalación Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para No Viking VCWB300RSS