Viking VCWB300RSS Guía de instalación descargar pdf (Pagina 11)

CUSTOM WOOD FACINGS DIMENSIONS

Short Facing Dimensions (Top Two Zones)

Tall Facing Dimensions (Lower zone)

Each wine rack has a wood facing which can be removed. The facings can be stained, painted, or removed and

replaced with alternative wood facings. NOTE: A scrap sample should be tested in the unit before attaching permanent

changes to your wine cellar fronts. Some paints and/or stains can cause undesirable odors.

Remove the wood facing by removing the four 1/4” (.6 cm) hex head screws located on the inner edge of the wine

ack. Remove the wood facing. Follow the dimensions below to cut wood facing out of alternative woods.

SSCCAALLEE 11..000000

Panels must not weigh more than 50 pounds per door.

re-drill the holes in the panel per the panel dimension instructions. (See panel dimensions for proper hole locations.)

lace the panel onto the door and using 1/2” #8 wood screws, attach the panel in 12 places. (2 at the top and bottom,

4 on each side) Note: The handle must be attached to the panel prior to installing the panel onto the door. See

panel dimensions for proper attachment locations of the handles.) Use the enclosed adhesive backed mylar pieces to

cover the screws after installation of the panel.

DOOR PANEL INSTALLATION - FULL OVERLAY MODEL

1 2 ... 6 7 8 9 10 11 12 13 14

Sin comentarios

Viking VCWB300RSS Guía de instalación Pagina 11