Viking E-1600A-BLT-EWP Especificaciones descargar pdf (Pagina 7)

Setting F - Pulse Dialing Rate (Pulses per second)

The 1600A series phone is capable of different pulse dialing speeds.

* Note: The factory default setting is 10pps.

Touch Tone

Setting F

10 pps*

20 pps

Setting C - Silence Time Out

This feature selects the length of time that calls will remain connected without voice activ-

ity. Programmable in increments of 10 seconds up to a maximum of 90 seconds (Touch

Tones 1 - 9). To disable the silence time out, program 0 in this location. Use chart at the

far right. * Note: The factory default is 40 seconds.

Touch

Tone

Silence

Time Out

Disabled

10 sec

20 sec

30 sec

40 sec*

50 sec

60 sec

70 sec

80 sec

90 sec

The 1600A series phone is factory set to automatically start playing the

voice announcement after it has determined the call has been answered.

Alternately, the announcement may be programmed to play after a pro-

grammed amount of time, from 1 to 99 seconds after dialing.

* Note: If the announcement delay time is used, you must allow enough time for the 1600A series phone to detect

ring-no-answer and busy signals when using the redial features. The factory default is set to play automatically.

Settings A and B - Announcement Delay

Touch Tone

01-99

Setting A/B

Play automatically

1-99 seconds*

G. Voice Announcer/Miscellaneous Options (memory location #17)

The 1600A series phones have a built-in non-volatile digital voice announcer that may be used to identify the location of the emer-

gency phone call. The 16 seconds of digital record time is recorded remotely from a Touch Tone phone. Programming options are

as follows:

Dial: A +B+C+D+E+F+#+1+7

Factory Default Setting:0+0 +1+2+ 1+0

Two Digit Announcement Delay {

Repeat Announcement Setting

Hang-up on Return to Dial Tone

Panasonic Mode

Lap Counter

Enter Settings Here:

A B C D E F

#17

If enabled and a busy is detected, the 1600A series phone will dial the next pro-

grammed emergency speed dial number, and continue to cycle through the emer-

gency numbers until a call is completed. * Notes: This feature is enabled in the

factory default setting. If the busy signal is interrupted with a promotional mes-

sage, contact your central office to have it removed.

Setting E - Dial Next Emergency Number on Busy

Touch Tone

Setting E

Disabled

Enabled*

Setting D - Dial Next Number on Ring No Answer

If enabled and a ring-no-answer is detected, the 1600A series

phone will dial the next programmed speed dial number, and con-

tinue to cycle through the emergency numbers until a call is com-

pleted. * Note: Factory set to redial if not answered after 7 rings.

Touch Tone

1 or 0

2, 3, 4...9

Setting D

Disabled

Dials second number after

2, 3, 4...9 rings respectively*

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

Viking E-1600A-BLT-EWP Especificaciones Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Viking E-1600A-BLT-EWP