Viking E-1600A-BLT-EWP Especificaciones descargar pdf (Pagina 5)

C. Security Code (memory location #19)

The security code allows the user/installer to program the 1600A series phone while DIP switch 3 is in the ON (normal)

position. The factory set security code is 845464 (V-I-K-I-N-G). It is recommended that the factory set security code

be changed. Example: To store 123456 as the security code:

Enter Your Security Code Here:

#19

Step 1. Access programming as shown is Programming section A.

Step 2. Enter 123456 #19..

Step 3. Hang-up.

Note: The security code must be 6 digits and cannot include a

or a #.

B. Quick Programming Features

First emergency speed dial number .........................................................................

Second emergency speed dial number ...................................................................

Third emergency speed dial number .......................................................................

Fourth emergency speed dial number .....................................................................

Fifth emergency speed dial number .........................................................................

Central station receiver number ...............................................................................

Central station voice number ...................................................................................

First “Info” speed dial number (E-1600A-BLT2-EWP) .............................................

Second “Info” speed dial number (E-1600A-BLT2-EWP only) .................................

Third “Info” speed dial number (E-1600A-BLT2-EWP only) .....................................

Voice announcer/miscellaneous options (factory set to 000210) .............................

Timing/Dialing options (factory set to 234111) .........................................................

Security code (factory set to 845464) ......................................................................

Identification number (factory cleared) ....................................................................

Second central station identification number (factory cleared) .................................

To add a

Q at any point in the dialing string ..............................................................

To add a # at any point in the dialing string ..............................................................

To add a four second pause at any point in the dialing string ...................................

To switch to pulse dialing at any point in the dialing string ........................................

To clear any speed dial number ...............................................................................

Diagnostic tones (used to check mic and speaker operation) ..................................

Exit programming and disconnect ...........................................................................

Reset all programming to factory default settings ....................................................

Note: A double beep indicates a valid memory position, four beeps indicate an error.

0-20 digits

6 digits

0-20 digits

(no digits)

###

#00

#01

#02

#03

#04

#05

#06

#07

#08

#09

#17

#18

#19

#20

#21

#00 - #09

Enter Digits

then

- then -

Enter Memory Location

D. Speed Dial Numbers

The emergency speed dial number programmed in location #00 is the number that

is dialed when the “HELP” / ”CALL” button is first pressed. Additional speed dial

numbers will be dialed when there is no answer or a busy signal is detected and the

next number redial features are activated. To program, enter the desired speed dial

number followed by the location number (#00 - #04). To clear a speed dial location,

simply enter the memory location (#00 - #04) alone. The 1600A series phone is

factory set with no speed dial number programmed.

1. Emergency Speed Dial Numbers

(memory locations #00 - #04)

Note: Up to 20 digits can be stored in each dial position. Special features such as pause, mode change, Touch Tone

and # count as single digits.

To Program:

4 second pause

switch to pulse mode

0, 1, 2...9

Enter:

0, 1, 2...9

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

Viking E-1600A-BLT-EWP Especificaciones Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Viking E-1600A-BLT-EWP