* Latch
Doorstrike
#11
#2
1
#3
1
#41
Un-Latch
Doorstrike
#10
#2
0
#30
#4
0
Momentarily
Activate
Doorstrike
#1
#2
#3
#4
Entry
Relay
1
2
3
4
C. Activating Doorstrike/Gate
You may activate the doorstrike relay without calling out
to the entry phone. Refer to the chart at the right for dial-
ing strings. When you momentarily activate a doorstrike
relay, it will activate for the amount of time specified in
Programming, section F.
* Note: The latch command can be disabled (see
Programming section B).
D. Privacy Number
The privacy number feature is useful for preventing unwanted (prank) entry phone calls from visitors. If a privacy number has been
programmed, an off hook entry phone is given 4 seconds of dial tone to allow the visitor to enter the privacy number. If the visitor
enters the correct privacy number, the C-2000A will ring the house phones. If they enter an incorrect number, they will be discon-
nected. If a privacy number is not programmed, then an off-hook entry phone will immediately ring the house phones. Note: The
“Privacy Number” may be programmed with the first 6 digits of the actual home/office phone number. Visitors may dial the actual 7-
digit phone number as if they are making an actual telephone call to the home/office.
E. Keyless Entry Codes and One Time Use Keyless Entry Codes
Touch Tone keyless entry codes may be used by the tenants to provide keyless entry. Each entry phone may have up to 6 keyless
entry codes. There are also up to 6 master keyless entry codes which can be used at all four entry locations. If a keyless entry code
has been programmed, an off-hook entry phone is given 4 seconds of dial tone before ringing the house phone. During this time a
Touch Tone “#” + the “keyless entry code” may be entered.
A correct keyless entry code will provide a timed doorstrike activation for that entry phone location. One time use keyless entry codes
function as described above but can only be used ONCE
. After the one time use keyless entry code has been used, it is instantly
cleared from the C-2000A’s memory. This is ideal for issuing keyless entry codes to service personnel, etc. Note: A short buzz
sound indicates when the relay has been activated and the visitor can now open the door.
F. Operation Commands
Activate doorstrike relay .........................................................................................................................................................
Continuously activate (latch) doorstrike relay ........................................................................................................................
Continuously de-activate (unlatch) doorstrike relay ...............................................................................................................
Toggle relay from last position ................................................................................................................................................
Answer or disconnect an entry phone call ..............................................................................................................................
Monitor entry phone 1 ............................................................................................................................................................
Monitor entry phone 2 ............................................................................................................................................................
Monitor entry phone 3 ............................................................................................................................................................
Monitor entry phone 4 ............................................................................................................................................................
1
0
#
#
# 1
# 2
# 3
# 4
Touch Tone
Commands
8
Toggle
Doorstrike
Relay
#1#
#2#
#3
#
#4#
G. Compatible Viking Equipment
The C-2000A is compatible with the Viking entry phones shown below, as well as any standard analog
phone. If auto-answer is required for monitoring, use Viking models E-10A, E-20B, E-30, E-35, E-40, E-50,
K-1700-3 or K-1705-3 as entry phones. If touch tone keyless entry is required, use Viking models K-1700-
3, K-1705-3 or K-1900-8.
Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or subsidiaries assume no respon-
sibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate such changes.
Fax Back Doc 156 ZF302090 Rev APrinted in the U.S.A.
P
P
r
r
o
o
d
d
u
u
c
c
t
t
S
S
u
u
p
p
p
p
o
o
r
r
t
t
L
L
i
i
n
n
e
e
.
.
.
.
.
.
7
7
1
1
5
5
.
.
3
3
8
8
6
6
.
.
8
8
6
6
6
6
6
6
F
F
a
a
x
x
B
B
a
a
c
c
k
k
L
L
i
i
n
n
e
e
.
.
.
.
.
.
7
7
1
1
5
5
.
.
3
3
8
8
6
6
.
.
4
4
3
3
4
4
5
5
Tenants may dial out to an entry phone that supports auto-answering capability by dialing “#1”, “#2”, “#3” or “#4” to call entry phones
1-4 respectively. All Viking Handsfree Entry Phones are equipped with an Auto-Answer feature.
B. Monitoring
Viking
K-1500-7
Viking
K-1900-8
(Fax Back 210)
(Fax Back
Doc 187)
(Fax Back
Doc 159)
(Fax Back
Doc 352)
(Fax Back
Doc 362)
Viking E-40/E-50 Door Entry Phones
SS BN PB WH BK
Viking Entry Phones
E-10A E-20B E-30 E-35
Viking Keypad Phones
K-1705-3 K-1700-3
(Fax Back Doc 191)
(Fax Back
Doc 157)
(Fax Back
Doc 212)
(Fax Back
Doc 178)
Comentarios a estos manuales