REAR OF UNIT
GARDEN HOSE
FITTING
5/8” (.63 cm) I.D. DRAIN
TUBING BARB
*MAKE CERTAIN ALL HOSE
CLAMPS ARE SECURE
COMPRESSION FITTING
2-1/4” (5.7 cm)
5-1/2” (14.0 cm)
1/4” (.64 cm) TUBING FROM
COLD WATER LINE
13
Water Supply
• This ice machine must be connected to a potable, active cold water supply line delivering water pressure at a
minimum pressure of 20 psi and maximum of 120 psi.
• Water connection is made through a 1/4” (.64 cm) compression right angle garden hose fitting. DO NOT use any
thread sealers. NOTE: The water line fitting supplied with your ice machine is to be used on a 1/4” (.64 cm) copper
water supply line only. Do not attach a plastic supply line to your unit using this fitting.
• A water filter is recommended for this unit. A quality filter can remove particles as well as remove taste and odors
from water.
• Do not use a reverse osmosis water filtration system with the ice machine.
• Softened water is not recommended. This will produce mushy, cloudy ice cubes that will stick together.
• De-ionized water is not recommended. This water will not form solid ice cubes.
• A water specialist can recommend proper water treatment.
• After installation of water line, turn on water and check for any leaks. Additional tightening may be needed. DO NOT
use any type of thread sealer.
• Allow extra water line for easy removal of unit and to help prevent the water line from kinking.
WATER CONNECTION
12
ELECTRICAL CONNECTION
Electrical Requirements
A 115 volt, 60 Hz, AC only 15 amp fused electrical supply is required. (A time
delay fuse or circuit breaker is recommended.) It is recommended that a
separate circuit, serving only this appliance, be provided.
•ELECTRICAL GROUND IS REQUIRED ON THIS APPLIANCE.
•DO NOT UNDER ANY CIRCUMSTANCES REMOVE THE POWER SUPPLY
CORD GROUND PLUG.
•DO NOT USE AN EXTENSION CORD.
Recommended Grounding Methods
For your personal safety, this refrigeration product must be grounded. This appliance is equipped with a 5’ power
supply cord having a 3-prong grounding plug. To minimize possible shock hazard, the cord must be plugged into a
mating 3-prong grounding type wall receptacle grounded in accordance with the National Electrical Code and local
codes and ordinances. If the circuit does not have a grounding type receptacle, it is the responsibility and obligation of
the customer to exchange the existing receptacle in accordance with the National Electrical Code and applicable local
codes and ordinances. The third ground plug SHOULD NOT, under any circumstances, be cut or removed. All UL listed
refrigerated products are equipped with this type of plug.
WARNING
ELECTRICAL SHOCK HAZARD
Failure to follow these instructions could result in fire or electrical shock.
Grounding type
wall receptacle
Power Supply
with 3-prong
grounding plug
Fitting
Valve
Adapter
Washer
Compression Fitting
Compression Nut
1/4” (.64 cm) copper
water supply line
(supplied by customer)
From water supply
to ice machine
(21 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales