J. DIP Switch Programming/Speaker and Microphone Adjustments
Two POTs are provided to increase or decrease speaker volume and microphone sensitivity. In certain noisy locations
the microphone sensitivity may need to be decreased as shown below. Caution: Setting the microphone gain too high
may cause distorted audio, prevent the distant party from breaking over and inhibit second number redialing.
DIP
Switch
1
1
2
2
3
3
Position
ON
OFF
ON
OFF
ON
OFF
Description
“HELP” / “CALL” button alternately connects
and disconnects calls (factory default)
“HELP” / “CALL” button connects calls only
Incoming calls answered (factory setting)
Incoming calls are not answered
Normal operation mode (factory setting)
Learn mode - Any incoming calls are auto-
matically entered into the programming
mode (no security code required). Use this
option if you have forgotten your security
code.
9.
H. Recording the Announcement
I. Automating the Call Connected LED
There are two methods of turning on the Call Connected LED. The LED will turn on after a Touch Tone 4 is detected
from the distant party or after the voice announcer is finished playing a programmed number of times. If you want the
Call Connected LED to light automatically when the call has been answered, but you don’t want a voice announcement
to be played, follow these programming steps:
Step 1:
Access Programming as shown in section A
Step 3:
Enter digits: 001000#17
Step 2:
Make a short (1 second) recording of silence
Step 1. Call into the 1600A series phone with a Touch Tone phone and access programming.
Step 2. Enter 44, wait for the tone and then begin recording. Sixteen seconds of record time is available.
Step 3. Enter any Touch Tone to stop the recording. Playback is automatic.
Step 4. Enter
45 to review the announcement again.
Step 5. If you choose to not use a voice announcement, enter 43 to clear the recording.
Example: “Elevator number 1215, located in the Financial Building, needs assistance. Press the asterisk (4) key on
your telephone to start and stop this announcement...”
The 1600A can be programmed to play the announcement from 1-9 times,
or to continuously repeat the announcement every 8 seconds until a
Touch Tone
4 is detected from the distant party. The I.D. number (if pro-
grammed) will be sent and the call connected LED will turn on automati-
cally after the announcement has stopped repeating.
* Note: The factory default for the 1600A series phone is to repeat until a
4
is detected (digit 0).
Touch Tone
0
1-9
Setting C
Repeat every 8 secs*
Repeat 1-9 times
Setting C - Repeat Announcement Option
The standard 1600A emergency phone is capable of communicating using the “Ademco Contact I.D.”, “Ademco High
Speed”, “DTMF 4+1 Express”, or the “DTMF 4+2 Express” formats. All formats use the programming memory location
#20 to store the account code and alarm details.
K. Central Station Programming
(8 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales