Viking AES-2005 Especificaciones descargar pdf (Pagina 3)

#2 Lock Washer (included)

#2-56 x 3/16 Phillips Screw (included)

Example:

Side View of

Model E-50

(not included)

A. Surface Mounting the VCAM-2

B. Mounting the VCAM-2 Faceplate

A Viking model VE-3x5 can be used to surface mount a VCAM-2 to a wall or post. Recommended mounting height to

bottom of VE-3x5 is 50” - 54”. Drill a small wire exit hole in wall. Pull wire through and seal hole around wire with putty

or caulking. Route wire into the VE-3x5 box, securely screw it to wall or post and seal hole in box around wire with

putty or caulking. Note: Conduit may also be used when surface mounting wire, but should not enter through the top

of the VE-3x5. When routing wiring from above, a drip loop is required. WARNING: Do NOT use a typical “wet loca-

tion box” as not all styles seal properly with the VCAM-2 faceplate.

After the Rough-In box or VE-3x5 is securely mounted, caulking between the box and rough opening is completed (if

required), wires are connected, and camera is tilted and rotated to the desired position (as shown in section G). Remove

paper liner from face plate gasket and press gasket to the back of the faceplate. Push the 1-1/4" 6-32 screws through face-

plate holes and small holes in gasket, the faceplate gasket should retain the screws. Position the camera mounting plate over

screws. Align screws with single gang box bosses and tighten face plate until gasket is fully collapsed. Included 1/4" thick

gasket will provide an adequate seal for most siding surfaces; however for rough surfaces (ie: brick, stucco, etc.) additional

caulking may be required.

(3) 3-Wire Gel-Filled

Butt Connectors

(included)

"Old Work" Rough-In Box

(Allied Molded 9331 box

shown, not included)

Camera

Mounting Plate

(included)

1/4" Thick Foam

Faceplate Gasket

(included)

Facplate

(included)

(2) 6-32 x 1.25" Long

5/64" Hexdrive Flathead

Screws (included)

4.875"

3.125"

(4) Optional Dry

Wall Screws

(not included)

Optional

Mounting Ears

Optional Wing

Brackets

*2.25"

Deep

Min.

Optional VE-3x5 Surface Mount

Box with Black Satin Powder Paint

Finish (not included) WARNING: Do

NOT use a wet location box.

1.8"

3.17"

4.92"

-OR-

Conduit Knockout

Condensation

Drain Hole

Wires from

Camera

Red

Black

Yellow

CAT5E

Cable

2.00"

Wide

Min.

O/W

W/O

G/W

W/G

2.84"

Tall Min.

C. Mounting the VCAM-1

IMPORTANT: Electronic devices are susceptible to lightning

and power station electrical surges from both the AC outlet and

the telephone line. It is recommended that a surge protector

be installed to protect against such surges.

Note: The recommended camera mounting height is

50.0” - 56.0” from the ground.

1 2 3 4

Comentarios a estos manuales

Sin comentarios

Viking AES-2005 Especificaciones Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Viking AES-2005