ZF300880 Rev B
Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking
Electronics, its affiliates and/or subsidiaries assume no responsibility for errors and/or omissions contained in this information. Revisions of
this document or new editions of it may be issued to incorporate such changes.
Product Support Line...(715) 386-8666 Fax Back Line...(715) 386-4345
Printed in the U.S.A.Fax Back Doc # 310
Operation/Applications
In the “dedicated dialer” mode, the K-1900-1 will dial a programmed phone number after the user has entered the
one or two digit memory position code. There is a single digit time out, so it is not necessary to enter 02 for memory
position 2, just enter 2. If that memory position has not been programmed, the K-1900-1 will disconnect and return
to dial tone. Manual user dialing is not allowed in the dedicated dialer mode.
Notes: If its required for users to enter digits after the K-1900-1 has speed dialed, program the unit to enable user
dialing (see Programming section B). If your telephone’s Touch Tones break dial tone while entering the desired
memory position, set the programming command to hang up before dialing (see Programming section B).
If 911 or 311 is entered, the number stored in emergency position one or two (respectively) will be dialed. If these
positions have not been programmed, 911 or 311 will be dialed.
B. Speed Dialer Mode (manual user dialing or speed dialing is allowed)
In the “speed dialer” mode, the user may use the K-1900-1 as a speed dialer or dial manually. If only one or two
Touch Tone digits are entered, the K-1900-1 will momentarily disconnect the telephone line (factory programmed
setting) and speed dial the phone number stored in the associated memory position. For faster speed dialing, enter
your 1 or 2 digit speed dial memory code followed by a # or ✱. This will bypass the three second time out and the
K-1900-1 will immediately begin speed dialing. If three or more digits are dialed by the user, the K-1900-1 is
transparent and will not dial, allowing the user to dial manually.
Note: The K-1900-1 will not restrict or disconnect in the “speed dial” mode.
A. Dedicated Dialer Mode (manual user dialing is not allowed)
Phone
Fax Back Document # 158
Viking Directory
(not included)
C.O. line or
analog PABX/KSU
extension
K-1900-8
(not included)
K-1900-1
VIKING©
K-1900-1
PROGRAM
100 NUMBER
AUTO DIALER
PHONE
Fax Back
Document # 362
C.O. line or
analog PABX/KSU
extension
K-1900-1
VIKING©
K-1900-1
PROGRAM
100 NUMBER
AUTO DIALER
PHONE
(4 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales