Viking VSOF730SS Guía de instalación descargar pdf (Pagina 28)

Installation Procedure (French Door- Upper Door Adjustment)

There may be ocassions where the upper doors are not aligned to the same height, especially if doors

were removed for maintenance and then reinstalled. With doors in the closed position determine the

alignment required, for example right door is higher than left door.

Alignment procedure:

1. Open doors fully

2. Loosen bottom hinge screws on both doors, see photos below.

Using a 5/32” allen wrench, adjust screw on each door shown below moving the door that is too high

downward and the door that is low upward. You want to adjust both in opposite directions, not just

one door. Note that this moves the lower hinge assembly when adjusted.

Close doors and check alignment, when

alignment is correct, open doors and tighten

the lower hinge plate screws that you

loosened at beginning of procedure.

1 2 ... 23 24 25 26 27 28 29 30 31 32

Sin comentarios

Viking VSOF730SS Guía de instalación Pagina 28