23
22
CChhaannggiinngg tthhee lliigghhtt bbuullbbss
EElleeccttrriiccaall SShhoocckk HHaazzaarrdd
DDiissccoonnnneecctt ppoowweerr aatt bbrreeaakkeerr oorr ttuurrnn
ppoowweerr ddiissccoonnnneecctt sswwiittcchh ttoo OOFFFF
ppoossiittiioonn
bbeeffoorree rreemmoovviinngg aa lliigghhtt bbuullbb..
FFaaiilluurree ttoo ddoo ssoo ccaann rreessuulltt iinn ddeeaatthh oorr
eelleeccttrriiccaall sshhoocckk
CCAAUUTTIIOONN
To avoid personal
injury or damage,
observe the following:
•Allow light bulb to
cool.
•Wear gloves when
replacing light bulb.
UUppppeerr LLiigghhtt BBuullbb
1. Disconnect power at breaker or turn power disconnect switch to
OFF position.
2. Lightly grasp light cover with both hands and pull down.
3. Replace bulb with an incandescent, medium base tubular bulb with
a maximum of 40 watts.
4. Replace cover by engaging light bracket with the back fingers on
the light cover. Once engaged, snap the front fingers on the light
cover. Note: The clear section of the light cover is considered the
back section.
5. Reconnect power or turn power disconnect switch to ON position.
Light Cover
Cover Fingers
DDoooorr GGaasskkeettss
Clean door gaskets every 3 months using same procedures as stated
for interior surfaces. Apply a light film of petroleum jelly to keep
gaskets pliable.
BBuurrnn HHaazzaarrdd
DDoo nnoott ttoouucchh ccoonnddeennsseerr ccooiillss
nneeaarr ddeeffrroosstt ppaann..
DDooiinngg ssoo ccaann rreessuulltt iinn bbuurrnnss..
EElleeccttrriiccaall SShhoocckk HHaazzaarrdd
DDiissccoonnnneecctt ppoowweerr oorr ttuurrnn
ppoowweerr ddiissccoonnnneecctt sswwiittcchh ttoo
OOFFFF ppoossiittiioonn bbeeffoorree rreemmoov
viinngg
ttoopp ggrriillllee.. FFaaiilluurree ttoo ddoo ssoo ccaann
rreessuulltt iinn ddeeaatthh oorr eelleeccttrriiccaall
sshhoocckk
DDeeffrroosstt PPaann
To prevent condensation from overflowing, check defrost pan
periodically. The defrost pan is located behind the kickplate. To
remove defrost pan, remove (4) screws in the kickplate. Clean the pan
and replace.
DDoooorr SSttoopp AAddjjuussttmmeenntt
Your unit is factory set at 110
o
door stop position. To change to either
the 90
o
or 120
o
position, remove door stop pin located in the bottom
hinge using a 3/16” allen wrench. For 120
o
swing, move pin to utmost
forward stop hole. For 90
o
swing, move pin to utmost rear stop.
120
o
90
o
Door Stop Pin
Comentarios a estos manuales