Viking 15"W Guía de instalación descargar pdf (Pagina 10)

INSTALLATION OVERVIEW

The ice machine must:

• Be connected to cold, potable water.

• Be connected to a drain.

• Be connected to the proper power supply.

• Be able circulate air through the vents at the front.

Note: DO NOT build in so that the door is recessed. Door is meant to be flush with surronding cabinetry, but

not recessed.

INSTALLATION PARTS

The following installation parts are supplied with the ice machine:

2-Hinge covers 2-Door stop pins

2-Hinge side covers 10-#8 sheet metal screws

2-Hole plugs 2-8-32 Machine screws

2-Hinge opening covers 4-Leveling leg caps

1-Upper door bracket (LH) 2-Black kickplate screws

1-Lower door bracket (LH) 1-Access panel button cover

ACCESSORY DOOR PANEL

The ice machine is supplied without a finished door panel. Accessory door panels are offered or a custom panel may

be used.

Accessory Door Panel Attachment

Note: If door swing is to be changed, it must be done before

panel is attached.

To attach a door panel:

The panel will be held on by 6 screws (supplied with door panel)

and 2 machine screws (supplied with ice machine).

1. Remove the gasket and retain for later use.

2. If the door panel is stainless steel, remove any plastic covering

the stainless steel panel.

3. Place the panel onto the outside of the door, and secure it to

the door using two machine screws, located at the left center

and right center ( behind door gasket).

4. Fasten the panel to the door using the 6 screws (supplied with

door panel). In the hinge area, use the outermost screw holes.

5. Place the covers over the hinge areas, and secure each cover to

the door using a screw (supplied with door panel).

6. Insert hole plug over screw installed in step 5 (supplied).

7. Return the gasket to its original position.

CUSTOM PANEL

A custom panel of wood or other material not exceeding 15 lb can be attached to the door. Attachment is from the ice

side of the door. Holes are provided in the door for this purpose.

To create and attach a custom panel:

• Panel width: 14-7/8” (37.9 cm)

• Panel height: 30-5/16” (77.0 cm)

• Panel thickness: 5/8” (14.5 cm) to 3/4” (1.9 cm)

1. Measure overall height of cabinet opening where ice machine will be (floor to botom of countertop edge).

2. Determine desired kickplate space (from bottom of door to floor). This could be equal to the adjacent cabinet’s

kickplate space or another space the user wants.

3. Subtract kickplate space from cabinet opening.

Hole

plug

Cover

Gasket

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comentarios a estos manuales

Sin comentarios

Viking 15"W Guía de instalación Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Máquinas productoras de hielo Viking 15"W